Novel Water-Cooled Wall Technology
During the blast furnace construction process, it is essential to ensure the formation of an internal cooling and protective wall through refractories injection. This refractory lining also serves as internal insulation and external heat insulation, effectively reducing heat loss. Typically, after one to two years of use, the internal cooling wall of a blast furnace will fracture, exposing the surface and increasing heat consumption, while also posing safety hazards. Therefore, without refractory material, slag will adhere directly to the cooling wall after combustion and cooling, and due to the significant differences in their expansion coefficients, the slag skin will easily detach. To effectively address this issue, a cermet lining can be applied for modification. This not only effectively protects the cooling walls but also enhances the refractory capacity through the application of thermally conductive fibers, while preserving the inherent metallic properties. This results in good thermal conductivity and excellent plastic deformation capabilities; even at high temperatures, the material will not exhibit brittle fracture.
Furnace Lining Injection Technology
Carbon monoxide inside the blast furnace causes carbon deposition in the refractory material, leading to structural damage. This manifests on the furnace wall primarily as internal fractures, reduced material strength, or spalling, resulting in irregular fracture ends. The presence of iron within the refractory material catalyzes this reaction, increasing the overall failure rate. Because ferric oxide is essential in all refractory materials, but it reacts with carbon monoxide to produce iron, which acts as a catalyst for carbon deposition. This problem is unavoidable under normal blast furnace operation, leading to a reduced lifespan.
Nano-silica combined with casting technology
After several years of use, blast furnaces experience varying degrees of wear at the taphole, reducing efficiency. Traditional repairs involve pressing in mud guns for improvement. However, this increases mud gun consumption and doesn't address the root cause. Therefore, new technologies are needed to modify the taphole. Currently, nano-silica combined with casting is a primary method for taphole repair. Using silicon carbide as the main raw material and silica as a gelling agent, it effectively improves overall structural strength, allows for rapid drying without explosion, and increases structural strength after repair.