Selection Of Raw Material Properties And Formulation For Sillimanite Bricks

Feb 15, 2026

Leave a message

Properties of Jixi Sillimanite

The Jixi Sandao Gou sillimanite mine is an open-pit mine. Linear sillimanite is distributed within crystalline granite, with a grade generally between 10% and 20%. The ore is crushed, ball-milled, and then floated. The ore body mainly contains quartz and sillimanite, followed by potassium feldspar, mica, ilmenite, and graphite, with recoverable reserves of 30 million tons and an annual production of 4,000 tons of sillimanite concentrate.

Jixi sillimanite has a relatively high conversion temperature and minimal linear expansion before conversion. When heated to 1545℃, it decomposes into quartz and mullite according to the formula, accompanied by a certain volume expansion.

 

Aggregate Selection

The particle size distribution of sillimanite shows that most coarse particles are below 0.2mm. Using it as coarse particles is too fine, while using it as fine powder is too coarse, posing a challenge to achieving a reasonable particle size distribution. Further sintering and granulation would significantly increase production costs. Therefore, it is essential to select appropriate coarse particles to meet the requirements of production and product performance. Mullite is a mineral with properties similar to sillimanite. The thermal expansion coefficient of synthetic mullite at 1200℃ is 0.53%, very close to that of natural sillimanite. Therefore, introducing coarse-grained synthetic mullite into sillimanite products is reasonable. After comparison, synthetic mullite from Chenxi, Hunan Province, with a mullite crystalline phase content ≥95%, was selected.

 

Selection of Binder

The physicochemical properties of the binder for sillimanite products should ideally be close to those of natural sillimanite, especially its chemical composition and thermal expansion coefficient. High-alumina binders meet these requirements and were therefore selected.

Through experiments, the composition range of the binder was determined, and physicochemical tests were performed on the binder samples.

Send Inquiry